Our Repair Portfolio

Customer reported no cooling. Diagnosed a failed compressor - replaced same day. Unit back to factory temp within 2 hours.

Loud grinding noise during spin cycle. Replaced worn drum bearings and seal. Machine running quietly again.

Gas oven not igniting. Faulty igniter diagnosed and replaced within the first visit. Baking back on track.

Standing water after every cycle. Replaced clogged drain pump - dishes coming out clean and dry.

Clothes taking 3 cycles to dry. Heating element tested failed - replaced and dryer running hot again.

Microwave running but not heating. Magnetron replaced - heating restored and unit certified safe.

Ice maker stopped producing ice. Water inlet valve replaced - ice maker producing full batch within the hour.

Water leaking from door gasket. New door boot seal installed - no more leaks, mold-resistant silicone used.

Control display going blank. Reprogrammed and replaced control board - all functions restored.

Drum not spinning. Broken belt and worn rollers replaced in one visit - dryer as good as new.

Freezer section freezing up, fridge warm. Evaporator fan motor replaced - temperature balanced across both sections.

Panel unresponsive to button presses. Control board rebuilt - all wash programs fully functional.

Burner not adjusting flame. Gas valve replaced and calibrated - full range control restored.

Error codes on display, cycle not starting. Main control board replaced - washer running all cycles normally.

Ventilation fan not engaging when cooking. Fan motor replaced - proper ventilation and airflow restored.